Formatting fat32 windows xp

Then, you can run Command Prompt and enter the command so as to change the partition file system. You should make sure that your computer would not reboot or shut down during converting in case of system crash or causing troubles to the partition. No option for FAT32 file system under format window? You have two options: 1. New English Interpretation! Clusters cannot be 64 kilobytes KB or larger. If clusters are 64 KB or larger, some programs such as Setup programs may incorrectly calculate disk space.

Some older programs that were not written for Windows NT 4. This behavior does not occur on a clean partition of NTFS. If you don't understand what dual-boot is, or if you do not have very specific reasons to set up a dual boot system, don't do it!! This is the second drive I purchased, the first had to be returned before 30 days were up due to numerous problems shown in the event viewer and the fact that the drive would disapper and I had to reboot to get it back.

This second Harddrive has been running perfectly for the 7 days that it has been installed, other than the slow transfer rate. I re-formatted the 1st drive as NTFS which seemed to make it much faster, but I wonder was this the cause of my problems. Windows 11 64 bit Pro SSD drives. Cakewalk by BandLab and Studio One 4. I have re-formated the drive to NTFS, it took less than a minute to delete the old partion and do a quick format using Disk Management.

I got the instructions on the WD site, does this seem correct? I am in the process of running an extended test using WD software and then will watch the drive for a few days to insure everything is ok this time. Browse Community.