Install ceiling light flush

Usually you'll have to remove the cover or glass globe by unscrewing a finial or screws. Then detach it from the ceiling, disconnect the old wires and take it down. Having a friend hold the light fixture while you connect the wires will make this part much easier. First, check the instructions for your ceiling light to see how it attaches to the box.

It's usually a pair of screws, or a central post. Make sure you have the parts handy. But before you attach it, you need to connect the wires first. Have your friend hold the light fixture a few inches below the ceiling while you connect the wires. How do you connect the wires? On the ends of the black and white wires there's a bit of exposed copper wire, which you twist tightly together and then cap firmly with a wire nut.

Make sure the light fixture is working before putting on the shade or glass cover. Back at your breaker box, turn the power back on. If the light doesn't turn on, double check all of your wiring connections.

But if you followed our easy guide, your flush-mount light fixture should be working perfectly ' finish up by installing the shade or light cover. At this time, you must be exposed to the junction box and all the wires within. Yes, power has been turned off, but to be double sure, test the wires with your voltage tester. They should all be dead. If they are not, do not touch! Go back and check your fuse box and be sure you turned off the right switch. Until you have tested and are sure that there is no live wire up there, please, do not go any further with the installation.

Now that you are sure that the wires are dead, you can go ahead to connect the new fixture wires to the wires from the ceiling. Be careful to join the ground wire from the fixture to the ground wire in the ceiling.

Do the same for the white wire and the black wire. The ground wire will most likely be green in color or a bare copper wire. Then fold them neatly and fit them into the junction box. After the wiring has been done, mount the base of the new fixture against the bracket and put the mounting screws in then tighten with the screwdriver. When that has been done, attach light bulbs to the socket and you are almost done with your installation.

But hey, remember to use bulbs with matching wattage as the ones that were previously there. Also, we recommend that you use LED or fluorescent bulbs instead of incandescent ones.

LED and fluorescent bulbs use up a lot less energy than incandescent light bulbs. LED Flashlight. LED Headlamp. LED Camping Lantern. Bedside Lamps. LED Bicycle Light.

Car Lights. Add anti-scratch pads to the back of the lamp body. Insert the wires into the electrical connections N and L accordingly. Pull the bracket lock and attach the lamp body to the fixed mounting bracket. Tags: ceiling lights flush mount ceiling lights how to how to install installation guide led ceiling lights. Jeanette Black April 16, at pm. Marco Sorokin April 16, at pm. You are a very smart person!